Osburn AC01340 Uživatelský manuál

45517A Printed in Canada 09-03-2015 FORCED AIR DISTRIBUTION KIT INSTRUCTIONS AC01340 INSTALLATION INSTRUCTIONS This manual is available

10 PC BOARD INSTALLATION AND WIRING Depending on the fireplace options, choose the appropriate installation instructions: A) Fireplace equipped wit

11 2 Connect the wires comming from the heat distribution blower and from the fireplace terminal to the PC board (see step 5). Then install the assemb

12 4 Finally, the ground terminal and the thermistor are to be secured to the fireplace frame (see Figure 4). Figure 4 5 Identify the common (whit

13 Figure 5 Figure 6

14 B) Fireplace not equipped with a wiring terminal 1 Determine a location on the side of your fireplace where you can drill a hole to run your elect

15 3 Secure the PC board assembly to the PC board bracket (see Figure 6). Figure 6 4 Secure the PC board bracket to the floor of the fireplace fr

16 5 Finally, the ground terminal is to be secured to the fireplace frame and the thermistor to the fireplace using the same metal screw already secur

17 Figure 9 Figure 10

18 PC BOARD OPERATION & CONFIGURATION  Press the ‘’Mode’’ button until the desired option light turns on. Press the ‘’select’’ button to save

19 Notes

2 This forced air distribution kit contains the following parts: PL53129 44142 49027 49090 1x 1x 4x 1x SE53131 60201 30414 1x 1x 3x 301

20 Stove Builder International inc. 250, rue de Copenhague Saint-Augustin-de-Desmaures Quebec, Canada G3A 2H

3 Option (not included): AC05558 Thermostat Tools required for installation: Flat Screwdriver Robertson Screwdriver Phillips Screwdri

4 Figure 1: Forced Air Distribution Kit

5 INSTALLATION 1 A warm air outlet can be connected on either side or rear of the unit. Remove the knock-out on the selected side. 2 If the meta

6 3 Cut out the insulation to the size of the opening. 4 Cut a notch on the perimeter of the adaptor as shown.

7 5 Align the adapter notch with the fireplace warm air outlet notch and turn until the flange is fully inserted. The adapter is well in place when it

8 6 Install the heat distribution blower in a location where, you will have access for maintenance and somewhere the fan’s noise will not be disturbin

9 7 Connect the insulated flexible aluminized trilaminated pipe (B) to the fireplace adapter (E), then to the inlet of the heat distribution blower (A